Roof vents, plumbing vents, louvered vents, furnace vents, etc.
Vintage New/Old Stock 12" Round Interior Roof Vent W/Screen. Has minor scuffs & small scratches.
Aluminum plumbing vent. Approximately 8 1/2" x 6". Tube portion is approximately 3 1/2" diameter.
This is a 19-3/4" x 14" Aluminum Refrigerator Vent Door w/ Hinge.
Overall Measurements without Hinge:
This is the bracket or cross brace that goes to a Spartan 12” x 16” roof vent. If your vent bracket is missing or all bent up, or you need to replace the vent operator, this part is what you need. It is made from .040 aluminum. It is...
New old stock, Ventline White 110V Sidewall Vent (fan not included). Model:V2215 CFM. This item may have some minor scuffs/scratches from being stored.
Front: 11"W x 11"H
Back: 11-5/8"W x 11-5/8"H
Range hood vent cover. This was salvaged from a 1950's New Moon. Does have some rust (as shown in photos) and is painted blue. The overhead electrical socket has the original wiring and has not been tested. The vent has a sliding cover and the screen may...
This interior roof vent has some rust, but can be cleaned up and painted. Has some surface rust. Vent opens fine. Product may vary from photos, but is very comparable.
Spartan Roof Vent Screen with an aluminum frame. The outside frame measurements: 15-1/4"h x 11-1/4"w x 1/4" depth. Inside opening measurements: 14"h x 10-1/8"w. The aluminum frame is bent but can be easily straightened. These vent screens do have some...
110V side wall exhaust vent. Tested and is in good working condition. Does need to be cleaned. Inside vent cover measurements are 11"H x 11"W. Mounting holes are roughly 7-1/8" center to center. Vent motor base measurements are 11-5/8"H x 11-9/16"W.
Square Corner Lower Side Vent. Cut out is 14" x 22". For use with most refrigerators. Comes in Colonial White but looks more Beige. Has a mill finish frame. Outside measurement is 15" x 23-1/8".
Piano style hinge. This item has...
Vent fits 14”x 14” rough opening with radius corners. Vent has original seals, which may need to be replaced. The plastic piece on the side of the operator is broken so one side does not crank up. It is also missing one crank handle. Needs...
This is a replacement fan motor and blade for Spartan bathroom ceiling vents. It has a steel mounting bracket. The motor is 110 volt with a 7" plastic fan blade. Photo of an original vent is for reference only. Comes with mounting bracket, fan motor,...